42 & 50 Inch Stamped Deck Leveling; 50 Inch Stamped Deck - Side-To-Side Leveling - Toro TimeCutter SW4200 Service Manual

MOWER DECK
42 & 50 Inch Stamped Deck Leveling
Check to ensure the deck is level any time you install the
deck or when there is an uneven cut recognized�
The deck must be checked for bent blades prior
to leveling; any bent blades must be removed and
replaced� Refer to the "Checking for Bent Blades"
procedure, in this chapter, before continuing�
The deck must be leveled side-to-side first then the front
to rear slope can be adjusted�
Requirements:
• The machine must be on a level surface�
• All four tires must be properly inflated.
42 & 50 Inch Stamped Deck - Side-to-Side
Leveling
1� Park the unit on a level surface and disengage the
PTO switch�
2� Move the motion control levers outward to the park
position, stop the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position�
3� Set the height-of-cut lever to middle position�
6
6-26
4� Carefully rotate the blades so that they are all side-
to-side (Fig� 126 and Fig� 127)�
B
C
D
Fig. 126
Mower decks with (2) blades
A� Blades side-to-side
B� Sail area of blade
C� Outside cutting edges
B
C
D
Fig. 127
Mower decks with (3) blades
A� Blades side-to-side
B� Outside cutting edges
C� Sail area of blade
Toro TimeCutter SS/MX/ZS Service Manual
A
C
B
D
fig. 51 G009682
D� Measure from blade tip
to level surface
C
B
A
D
fig. 52 G005278
D� Measure from blade tip
to level surface