About This Manual - Toro TimeCutter SW4200 Service Manual

This service manual was written expressly for Toro service technicians. The Toro Company has made every effort to
make the information in this manual complete and correct.
Basic shop safety knowledge and mechanical/electrical skills are assumed. The Table of Contents lists the systems
and the related topics covered in this manual.
For service information on drive systems, please refer to the Hydro-Gear ZT-2800/ZT-3100/ZT-3400 service manual
(BLN 52441) and the Hydro-Gear ZT-2100/ZT2200 EZT service manual (492-4778). For information specific to the
engines used on this unit, refer to the appropriate engine manufacturer's service and repair instructions.
Toro TimeCutter® SW and Toro TimeCutter® SWX are covered in this manual. The manual may also be specified for
use on later model products.
The hydrostatic transaxle is a sophisticated piece of machinery. Maintain strict cleanliness control during all stages of
service and repair. Cover or cap all hose ends and fittings whenever they are exposed. Even a small amount of dirt or
other contamination can severely damage the system.
If you have any questions or comments regarding this manual, please contact us at the following address:
The Toro Company
Residential and Landscape Contractor Service Training Department
8111 Lyndale Avenue South
Bloomington, MN 55420
The Toro Company reserves the right to change product specifications or this manual without notice.
©2015 The Toro Company.
All Rights Reserved.

ABOUT THIS MANUAL