Toro TimeCutter SW4200 Service Manual page 58

STEERING SYSTEM - ALIGNMENT - ZERO TURN TRACTOR
7.Lift up the seat and insert a 1/4 in. dowel pin
through both alignment boles on both sides
of the hydro rod bell cranks. The dowel pins
should touch the bell cranks.
Bell Cranks
1/4 in. Dowel Pin
8. If one of the hydro-locking dowel pins does
not insert properly, adjust the length of the
corresponding control rod from the speed
control assembly by removing the nut and
turning the tie rod end (A) until the pin inserts
freely and contacts the bell crank.
Toro TimeCutter SW/SWX Service Manual
1/4 in. Dowel Pin
CHASSIS
1/4 in. Dowel Pin
1/4 in. Dowel Pin
1/4 in. Dowel Pin
A
3
3-35