Toro TimeCutter SW4200 Service Manual page 80

9. Install the brake rod to the brake actuator module
(Fig. 086).
Fig. 086
10. Install the bypass lever, washer(s) and retaining clip
(SWX shown) (Fig. 087).
Fig. 087
Toro Timecutter SW/SWX Service Manual
HYDROSTATIC DRIVE SYSTEM
16. Install the rear hydro rod and torque the nut to speci-
fication - 17 ft-lbs. (23 Nm) (Fig. 088). Hold the rod
securely while tightening nut.
IMG-0968a
11. Install the rear wheels and torque lug nuts to
specification – 80 ft-lbs. (108 Nm).
12. Connect battery terminals.
13. Safely lower unit.
14. Verify hydro oil level. If equipped, add 20w50 engine
oil to the hydro reservoir FULL COLD mark.
15. Perform the purging procedure as shown in this
chapter.
16. Perform the neutral and tracking adjustment
procedures as shown in this chapter.
17. Verify proper oil level and function.
PICT-1096
Fig. 088 PICT-1097
5
5-15