4� Carefully rotate the blade so that it is side-to-side
(Fig� 120)�
A
D
Fig. 120
A� Blade side-to-side
B� Sail area of blade
C� Outside cutting edges
5� Measure between the outside cutting edges and the
level surface (Fig� 120)� If both measurements are
not within 3/16" (5mm), an adjustment is required;
continue with this procedure�
6� Support the weight of mower deck by placing wood
blocks under the edges of the deck�
Note: Avoid placing the supports under any anti-
scalp rollers if present on the deck.
Toro Timecutter SS/MX/ZS Service Manual
C
B
D
fig. 48 G014630
D� Measure from blade tip
to level surface
MOWER DECK
7� Move to the left side of the machine� Remove the
side carriage bolt (E) and locking nut (D) from the
fixed position (C). Install it into the rear slotted
position (B) (Fig� 121)� Leave the lock nut slightly
loose�
E
C
D
Fig. 121
A� Hanger bracket
B� Slotted adjustment
position
A
B
fig. 49 G015323
C� Fixed position
D� Side locking nut
E� Side carriage bolt
6-23
6