Toro TimeCutter SW4200 Service Manual page 57

CHASSIS
The spacer should surround the nut on the tie rod
and verifying the steering column is straight.
3
4. If the right side wheel (when sitting on machine)
is not straight, adjust the tie rod ends on the
short tie rod (A) until the wheel is positioned in
a straight forward position.
A
3-34
STEERING SYSTEM - ALIGNMENT - ZERO TURN TRACTOR
A
5. If the left side wheel (when sitting on the
machine) isn't straight, adjust the tie rod on the
long tie rod (B) until the wheel is positioned in a
straight forward position.
6. Insert on of the 1/4 in. dowel pins through the
holes in the speed control assembly and
through the hole in the frame.
If the pin does NOT fit, you will need to install
a pin through the traction pedal and adjust the
tie rod end on the pivot lever assembly. See
steps 3 and 5 in the "Speed Control Assembly"
Service Instruction Sheets.
Toro TimeCutter SW/SWX Service Manual