Oki Teriostar LP-1030 User Manual page 209

Cause
The protocol (XPT, FTP, Are the settings on the device side
and LPR) is not set. of the used protocols (XPT, FTP, LPR)
enabled?
The lpr printer name is Do the printer names on the host side
incorrect (when using the and device side match?
LPR protocol).
The ftp user name is Does the user name specified from the
incorrect (when using the host side match the user name set on
FTP protocol). the device?
The ftp password is Does the password specified from the
incorrect (when using the host side match the user name set
FTP protocol). on the device (the user name is the
password on the device)?
The TCP port setting is Do the TCP port addresses on the host
incorrect. side and device side match?
The network settings Check with the system administrator.
such as TCP protocol,
on the host side are
incorrect.
„ When there are output result errors
Cause
Binary is not specified Is data sent after issuing the FTP
(during FTP connection). command (bin)?
Check
Enable the settings of the used
protocols.
Set the correct printer name. (The
setting method differs between UNIX
and Windows. Check with the system
administrator.)
Use the correct user name, or change
the user name setting of the device.
Use the correct password, or change
the user name setting of the device.
Set the correct XPT port address.
Set the host side correctly. (The setting
method differs between host devices.
Check with the system administrator.)
Check
Issue the bin command before sending
the data to the device. (However, with
some host devices, bin is not issued
even after setting the bin specification.
In such a case, set the setting on the
device side to bin fixed.)
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
Ethernet Troubleshooting
T
Action
Action
Chapter
1
Chapter
2
Chapter
3
Chapter
4
Chapter
5
209