Oki Teriostar LP-1030 User Manual page 117

Same Drawing Size with
Top and Bottom Blank = 0 mm
printed image
Y
X
Paper feed direction
n
X Offset
n
Y Offset
The parameter specifies the X, and Y offsets. They are valid when the Offset Mode
is set to Offset with Paper Size Change or Offset without Paper Size Change.
The parameter setting is invalid on the conditions below:
- HP-GL data is specified;
- The image data was created with the image center set to the coordinate origin; and
- The data is printed with setting Page Size to Actual Size.
<Parameter by entering numbers>
-9999.99 to 9999.99
n
Writing Mode (only with HP-GL and D-SCAN)
The parameter specifies the overwriting mode when the images overlap. Note
that, with HP-GL data, the writing mode specified with data is prioritized over the
setting with touchpanel.
<Parameter by selecting options>
Overwrite
n
Delete and Write
Y
Cut position
Default value = 0, Unit in mm
: Default value
n
Overwrites.
Deletes and writes.
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
Setup Items in PDL Settings Menu
T
Same Drawing Size with
Top and Bottom Blank ≠ 0 mm
a
printed image
a
X
Paper feed direction
a: Speci ed value
Chapter
1
Chapter
2
a
Chapter
Cut position 3
Chapter
4
Chapter
5
117