Oki Teriostar LP-1030 User Manual page 120

Setup Items in PDL Settings Menu
T
Chapter
1
Chapter
2
Chapter
3
Chapter
4
Chapter
5
120
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
Image
z
X Scale (%)
z
Y Scale (%)
The parameters specify the scale values in x and y directions when the Scale Mode
is set to Manual Scale.
<Parameter by entering numbers>
0.01 to 1000.00
Numbers indicate percentage for scale.
z
This setting is enabled when the Scale Mode is set to Manual Scale. When the setting
z
is 100%, the image is printed at the same size.
z
Pen Width Scale (only with HP-GL and D-SCAN)
The parameter selects the scale mode applied to lines when an image is scaled
with x ratio equal to y ratio.
The lines includes:
- Solid lines
- Lines with dots and/or dashes repeated
<Parameter by selecting options>
Off
On
n
Auto Scale
Image
Y
X
Paper feed direction
Default value = 100, Numbers indicate percentage for scale.
: Default value
n
The parameter does not apply the scaling to:
- Line widths
- Inter-dot distance
- Dash-dot distance
The parameter applies the scaling to:
- Line widths
- Inter-dot distance
- Dash-dot distance
However, note that the maximum line width is 16 mm.