Oki Teriostar LP-1030 User Manual page 129

n
Language (only with HP-GL)
With this parameter, the received data is handled as HP-GL or HPGL/2.
When Auto is selected, the data is automatically identified.
The selection of HP-GL or HP-GL/2 affects the coordinate origin definition.
<Parameter by selecting options>
Auto
n
HP-GL
HP-GL/2
With HP-GL, the coordinate origin is at the center of the print area, while with HP-
z
GL/2, it is at the bottom left.
No error occurs even if HP-GL/2 data is received with HP-GL selected.
z
n
Terminator PG1;
n
Terminator NR;
n
Terminator SP0;
n
Terminator ESC.)
n
Terminator AF;
n
Terminator AH;
n
Terminator FR;
Each parameter above specifies the print end.
Be sure to set the Terminator SP0 to Off when you apply SP0 to your drawing pen,
or your pen 0 is taken as a terminator.
<Parameter by selecting options>
Off
On
n
T
: Default value
n
The parameter identifies HP-GL or HP-GL/2 automatically.
The parameter identifies the received data as HP-GL.
The parameter identifies the received data as HP-GL/2.
: Default value
n
Does not set the command as a terminator (EOF).
Sets the command as a terminator (EOF).
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
Setup Items in PDL Settings Menu
Chapter
1
Chapter
2
Chapter
3
Chapter
4
Chapter
5
129