Oki Teriostar LP-1030 User Manual page 207

(1) (2) (3) Message
W SP A100 Cannot Determine Data
Fomat
W SP A110 No PDL Choice(Port %d)
W SP C000 Spool Mng File Not Found
W SP C010 Spool Mng File Broken
W SP C020 Spool Data Restore Fail
W SP C030 Unknown File Removed
W SP C100 Spool Data Removed - Job
Unmatch
W SP C200 Spool area overflow XX
W SP C210 Recover spool overflowl XX
W TW 4000 Twain : error taskIF
W TW 6000 Twain : warn setup
W TW 8300 Twain : use socket
W TW 8301 Twain : proc socket
W TW 8302 Twain : undefine command
W TW 8303 Twain : read socket
W TW 8304 Twain : write socket
W TW 8320 Twain : broken pipe
W TW 8331 Twain : addr not avail
W TW 8333 Twain : net unreach
W TW 8336 Twain : connect reset
W TW 8337 Twain : no buffer
W TW 8339 Twain : not connect
W TW 8341 Twain : host unreach
W TW 8343 Twain : host down
W TW 833C Twain : time out
W TW 833D Twain : connect refused
W TW 83FF Twain : others (net)
(1) Type (2) Character string (3) Error number
Meaning
Format automatic identification failed
Not even 1 valid PDL at port %d
No spool management file
Previous shutdown may not have been
performed correctly
Spool management file error
Deleted the corresponding data item
because of spool data restore failure
Deleted unknown files not matching the
management data in the spool partition
Deleted the spool data not compatible with the
job list
Entered the spool area overflow status
XX: Area number
Recovered from the spool area overflow status
XX: Area number
Fatal error occurred during communication
initialization between tasks
Cannot read the setup correctly
Socket general error
Socket process error
Socket command error
Socket read error
Socket write error
Network error
Network error
Network error
Network errors other than above
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
Error Log Reference
T
Action
Check the print data.
Change the Printer's port settings,
and restart the Printer.
-
-
-
-
-
-
-
Contact your nearest service
representative.
Restart the Printer.
• Check the communication status
with the ping command.
• Check the network cable
connection and disconnection.
• Check that the computer power is
on.
• Check that the router/switch power
is on.
• Check the Printer's network
settings.
• Check the computer's network
settings.
• Check the other network settings.
If the error persists, replace the ARC
substrate.
Chapter
1
Chapter
2
Chapter
3
Chapter
4
Chapter
5
207