Installing The Aileron Servos; Installing The Spinner - Seagull Models 10CC Assembly Manual

5) Attach the speed control to the side
of the motor box using two-sided tape
and tie wraps. Connect the appropriate
leads from the speed control to the mo-
tor. Make sure the leads will not interfere
with the operation of the motor.
Tie wraps.
Battery.

INSTALLING THE SPINNER.

Install the spinner backplate, propeller
and spinner cone.
WWW.SEAGULLMODELS.COM
Speed control
The propeller should not touch any
part of the spinner cone. If it does, use a
sharp modeling knife and carefully trim
away the spinner cone where the propel-
ler comes in contact with it.

INSTALLING THE AILERON SERVOS.

Servos
.
Because the size of servos differ, you
may need to adjust the size of the precut
opening in the mount. The notch in the
sides of the mount allow the servo lead to
pass through.
Small weight
.
Thread
15