Seagull Models 10CC Assembly Manual page 16

FUNKY CUB 10cc-15cc
1) Using a small weight (Weighted fuel
pick-up works well) and string, feed the
string through the wing as indicated.
Small weight.
2) Place the servo between the mounting
blocks and space it from the hatch. Use a
pencil to mark the mounting hole loca-
tions on the blocks.
3) Use drill bit in a pin vise to drill the
mouting holes in the blocks.
4) Apply 2-3 drops of thin C/A to each
of the mounting holes. Allow the C/A to
cure without using accelerator.
16
5) Use dental floss to secure the connec-
tion so they cannot become unplugged.
String.
6) Secure the servo to the aileron hatch
using Phillips screwdriver and the screws
provided with the servo.
7) Apply 1-2 drops of thin C/A to each of
the mounting tabs. Allow the C/A to cure
without using accelerator.
8) A string has been provided in the wing
to pull the aileron lead through to the
.
wing root. Remove the string from the
wing at the servo location and use the
tape to attach it to the servo extension
lead. Pull the lead through the wing and
remove the string.
C/A glue
Instruction Manual.
C/A glue
.