Table of Contents
Advertisement
INSTALLING THE FUSELAGE SERVOS.
Because the size of servos differ, you
may need to adjust the size of the precut
opening in the mount. The notch in the
sides of the mount allow the servo lead to
pass through.
1) Install the rubber grommets and brass
collets onto the throttle servo. Test fit the
servo into the aileron servo mount.
2) Secure the servos with the screws pro-
vided with your radio system.
Elevator servo.
Throttle servo.
Elevator servo.
THROTTLE SERVO ARM
INSTALLATION.
Install adjustable servo connector in the
servo arm as same as picture below:
Loctite secure.
Throttle servo arm.
WWW.SEAGULLMODELS.COM
.
Rudder servo.
Adjustable servo
connector.
Servo arm.
INSTALLING THE SWITCH RECEIVER.
Install the switch into the precut hole in
the side, in the fuselage.
INSTALLING THE SWITCH ENGINE.
Trim and cut.
3/32" Hole.
Trim and cut.
.
Switch.
9
Advertisement
Table of Contents
