Automatic Standby Function; Simultaneous Playback Of Picture And Sound; Ant In / Out Loop Through (Loop Standby) - Mirage BOX2IP User Manual

Extended Settings and Functions

9.12 Automatic Standby Function


1. Select in the menu System setup the submenu Other and press OK.
2. Select Auto Standby to switch on or switch off the automatic standby
function, using the keys
On
Standby ).

9.13 Simultaneous Playback of Picture and Sound

Asynchrony between the image and the sound signals might for example
occur in your home cinema system due to the use of long cables. Your
receiver offers the possibility to balance this by slightly shifting the audio
against the video signal.
1. Select in the menu System setup the submenu Other and press OK.
2. Select AV Sync Value to set a value of shift between
+500ms
using the keys
0 ms
ue ).

9.14 ANT IN / OUT Loop Through (Loop Standby)

Basically, after turning off the receiver it switches to power saving mode
("Deep Standby", red LED lights up). At the ANT OUT terminal there is no
or only a highly attenuated signal. If you want to use ANT OUT anyway,
you can set that in the submenu Other of the System setup menu:
 Select Loop Standby to switch on and off the possibility of looping
through the satellite signal, using the buttons
default is Loop Standby
62
Based on current EC regulations, this receiver is
equipped with an energy saving system. After three
hours, the receiver will automatically switch to energy
save mode (energy consumption of less than 0.5 W) un-
less a function is triggered via remote control during
such period (e.g. volume change or switching of chan-
nels). You can deactivate the automatic standby func-
tion via the menu.
and
und
off
).
(factory setting is Auto
-500ms
(factory default is AV Sync Val-
und
and
(factory