Insert Batteries Of Remote Control - Mirage BOX2IP User Manual

4.9 Insert Batteries of Remote Control

This describes the steps for inserting new batteries of the remote
control or for replacing empty batteries:
1. Open the battery compartment on the bottom side of the remote con-
trol. Remove the cover of the battery compartment.
2. Place the two batteries 1.5 V (type: AAA).
Ensure correct polarity!
3. Close the battery compartment

 Replace the batteries if certain remote control func-
tions are not performed any more or are performed
incorrectly.
 When replacing batteries, always ensure that all bat-
teries are replaced.
Installation of the Receiver
21