Troubleshooting - Mirage BOX2IP User Manual

12 Troubleshooting

This section includes a list of general errors that could occur with opera-
tion of the receiver. Each error states a possible cause and solutions.
Symptom
The display does
not light.
No audio or video;
the receiver states
"OFF" and the red
LED lights up.
No audio or video.
The TV set does not
show a picture.
Picture only in black
and white and/or
incorrect synchroni-
zation.
The remote control
does not operate.
Display flashes
Possible cause(s)
The power cord is not
connected.
The power switch is not
switched on.
The receiver is in standby
mode.
No signal or only weak
signal.
The system is not cor-
rectly connected.
The video format of your
receiver is not correctly
set.
The batteries are empty.
The remote control shows
into wrong direction.
Short circuit at antenna
in.
Troubleshooting
Solution
Connect the power cord to the
power outlet.
Switch on the power switch.
Press the POWER key to switch
on the receiver.
Check the cable connections to
the receiver and from the receiver
to the connected devices; fasten
cables, if required.
Verify connection of cable and
fasten cable, if required.
Adapt broadcast television system
of the receiver to the broadcast
television system of the TV set.
Replace empty batteries with new
batteries.
Direct the remote control towards
the front panel of the receiver.
Pull off antenna plug from ANT IN
and check the same.
Verify that your cable installation is
properly installed.
65