Mirage BOX2IP User Manual page 24

Basic Operation
With RASS the channel list will always be up to date, even if new channels
are added or if there are other changes.
5.1.3.1.2 RASS Works as Follows:
1. A RASS list is installed on the receiver already in the factory. This list is
processed during the initial installation after the search, i. e., the found
channels are stored in a predefined order.
2. Occasionally it happens that cable operators feed a new channel, or
remove any existing channels from their network. From this reason it is
important that the channel list is kept up to date. Therefore, your re-
ceiver checks each time that you turn off your receiver (in standby
mode), if there is a RASS update. If not, the receiver is completely
switched off after a certain time, then he goes into the power saving
mode (Deep Standby).
3. However, if the receiver determines that a new RASS-update is availa-
ble, this will be loaded. Thereafter, the receiver will also turn off com-
pletely.
4. Next time you turn on the receiver, you will get a message: "RASS: It is
recommended to perform an automatic tuning". Then you have the
choice between
− If you select
channels get re-sorted using the new RASS list.
− If you select
done and the above message will even not appear during the next
turning on. You can always achieve a re-sorting of the channels
based on the current RASS list by starting manually a full scan.
5.1.3.2 Denmark, Sweden or Norway
If you select the countries Denmark, Sweden or Norway, Max NorDig, a
special kind of LCN will be used during creation and updating your chan-
nel list. LCN is an acronym for "Logical Channel Numbering", which
means that a channel list given by the cable TV provider can automatically
be loaded into the receiver (and therefore be updated at any time).
24
OK Cancel
and .
OK
, the receiver makes a complete cable-scan and the
Cancel
, the receiver is started normally, no scanning is