Filter/Dynamic - Korg PA1X User Manual

330 Effects

Filter/Dynamic

Filter/Dynamic
Filter and dynamics control effects
000: No Effect
Select this option when you do not use any effects. When this
option is selected, the effect is muted.
001: Amp. Simulation
This effect simulates the frequency response characteristics of
guitar amplifiers. It is also effective for organ and drum sounds.
Stereo In - Stereo Out
Left
Amp Simulation Filter
Amp Simulation Filter
Right
Amplifier Type
a Selects the type of guitar amplifier
Wet/Dry
Sets the balance between the effect and dry sounds
Src
b
Selects the modulation source of the effect balance
Amt
Sets the modulation amount of the effect balance
002: Compressor
This effect compresses the input signal to regulate the level and
give a "punchy" effect. It is useful for guitar, piano, and drum
sounds. This is a stereo compressor. You can link left and right
channels, or use each channel separately.
Wet / Dry
a
b
Wet / Dry
d
Solid State, British
(EL84), American
e
(6L6)
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100
g
a: Envelope Select
This parameter selects whether the left and right channels are
linked to control both signals simultaneously, or whether each
channel is controlled independently.
b: Sensitivity, f: Output Level
The "Sensitivity" parameter sets the sensitivity of the compressor.
If this parameter is set to a higher value, lower level sounds will
be boosted. With a higher Sensitivity, the overall volume level is
higher. To adjust the final volume level, use the "Output Level"
parameter.
Stereo In - Stereo Out
Left
EQ Trim
LEQ HEQ
Envelope - Control
Envelope Select
Envelope - Control
EQ Trim
LEQ HEQ
Right
Envelope Select
Determines whether the left and right channels are linked or used separately
☞
Sensitivity
Sets the sensitivity
Attack
c
Sets the attack level
EQ Trim
Sets the EQ input level
Pre LEQ Gain [dB]
Sets the gain of Low EQ
Pre HEQ Gain [dB]
Sets the gain of High EQ
Output Level
Sets the output level of the compressor
Src
f
Selects the modulation source for the compressor output level
Amt
Sets the modulation amount of the compressor output level
Wet/Dry
Table , "Sets the balance between the effect and dry sounds," on page 330
Src
Table , "Selects the modulation source of the effect balance," on page 330
Amt
Table , "Sets the modulation amount of the effect bal-
ance," on page 330
Level
Wet
Dry
Wet / Dry
Compressor
Output Level
Output Level
Compressor
Wet / Dry
L/R Mix, L/R Individually
1...100
☞
1...100
☞
0...100
–15.0...+15.0dB
–15.0...+15.0dB
0...100
☞
,
Off...Tempo
–100...+100
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100
Compressor - Sensitivity
Sensitivity=100
Sensitivity=40
Time