Voice Processor Setup: Talk - Korg PA1X User Manual

244 Global edit mode

Voice Processor Setup: Talk

Mid Gain knob
Mid Band Frequency cut/boost. Range: ±12 dB.
Mid Frequency knob
Mid Band Frequency center frequency. Range: 80Hz...16kHz.
Mid Q knob
Resonance of the midband. Range is .1 (wide band) to 10 (very
narrow band).
High Gain knob
High Shelving Frequency cut/boost. Range: ±12 dB.
High Frequency knob
High Shelving Frequency
80Hz...16kHz.
Voice Processor Setup: Talk
This page is where you can set the Talk function, to be used to
address the audience, speaking over the background music.
Parameter contained in this page are relative to programming
parameters, and are used to attenuate the music when speaking.
Talk
Talk
On/off switch for the Talk function. This is the same you can
find in the Mic panel of the Style Play and Song Play modes.
Mode
Auto (AutoTalk)
When this parameter is checked, the Talk function automatically
engages when the Sequencer or Arranger is stopped. This way,
you can talk to the audience between two songs, without the
need to press the Talk On/Off button.
Mixer
Ld to Rv (Lead to Reverb) knob
Use this knob to attenuate the reverb applied to the lead voice.
0dB corresponds to no attenuation.
VPs
VPs
VPs
VPs
VPs
center frequency. Range:
Tlk
Tlk
Tlk
FX Lev (FX Level) knob
Use this knob to attenuate the effects level. 0dB corresponds to
no attenuation.
Master Volume Attenuation knob
Use this knob to reduce the master volume. 0dB corresponds to
no level reduction.
Reverb
Type
Use this parameter to choose a reverb to be automatically
selected when turning the Talk function on.
PreDly (Pre Delay)
Use this parameter to delay the reverb, and separate it from the
lead voice. With higher values, reverb may be perceived as an
echo.
Decay
Use this parameter to set the reverb's decay time (in seconds).
The higher this value, the more difficult is to understand sepa-
rate words.
Low Color
Reverb Low Color. Specifies the characteristics of the reverbs low
frequencies.
High Color
Reverb High Color. Specifies the characteristics of the reverbs
high frequencies.
Thicken
On/Off
This checkbox allows enabling/disabling of lead voice thickening
parameters.
Det. (Detune)
Sets the amount of lead voice detuning.
Spread
Sets the amount that the detuned voices are panned. A value of
100% results in the detuned voices being hard panned R and L.
A value of 0% results in the detuned voices panned to center.
Level
Level knob
Use this knob to set the level of the voice thickening effect.
Tlk
Tlk
Tlk
Tlk
Tlk
Tlk
Tlk
Tlk
Tlk
Tlk
Tlk