Korg PA1X User Manual page 268

264 Disk edit mode
Load
7. Select the item you are looking for, and press Load to con-
firm the load. A dialog box appears, asking you to select
one of the available User locations in memory.
In the dialog box above, the previously selected Style will be
loaded into location 01 of the bank U01 (USER1 button) in
memory. The existing Style at the same memory location
will be deleted and overwritten.
Empty locations are named <empty>.
8. Select the target location, and press OK to load the source
file.
Warning: After confirming, the item you are overwriting in
memory will be deleted.
Loading i-Series data
Pa1X is compatible with the Styles of the older i-Series instru-
ments. You can load them as if they were ordinary Pa1X data.
1. Insert an older i-Series floppy disk into the disk drive.
2. Press DISK to go to the Disk mode. Select the Load page if
needed.
3. While in the Load page, select the floppy disk (FD) from
the Device pop-up menu.
4. If you are reading an i30 disk, select the ".SET" folder and
press the Open button in the display.
5. Select the ".STY" folder.
6. At this point, you can load the whole ".STY" folder, or open
it and select a single Style.
• To load the whole folder, press the Load button in the
display. If it contains more than 16 Styles, they will be
loaded into the USER banks sequentially, otherwise you
will be prompted to select one of the three USER Style
banks in memory. Once the target bank is selected, press
Load to load the bank. The "Are you sure?" message will
appear. Press OK to confirm, or Cancel to abort.
• To load a single Style, press Open in the display to open
the ".STY" folder. Since a conversion will be started at
this point, please wait some seconds for the operation to
be completed.
Select the Style to load, then press Load. You will be
prompted to select a target location in memory. Once
the target location is selected, press Load to load the
Style. The "Are you sure?" message will appear. Press OK
to confirm, or Cancel to abort.
Note: Loading a whole ".SET" folder from an i30 disk may
take very long. You are advised to load a single bank or a
single Style a time.
7. Go to the Style Play mode, and select (one of) the loaded
Style. Adjust the Tempo, then select the "Write Current
Style Performance" to write changes to the Style Perfor-
mance. Press OK twice to confirm.
8. Due to difference in Sounds, you will probably make some
adjustment to the old Styles, once they are loaded in Pa1X
(changing the Sound, Volume, Pan, Tempo, Drum Map-
ping, Wrap Around...).
9. To make the Sound assignment to the Style tracks effective,
be sure the "Original Style Sounds" parameter is not
checked (see page 80).
10. Save the Style Performance again. Select the "Write Current
Style Performance" to write changes to the Style Perfor-
mance. Press OK to confirm.
Loading Pa80/60 data
You can load Pa80/60 data exactly as if they were Pa1X data. The
only difference is that the "SOUND" folder of Pa1X is called
"PROGRAM" in the Pa80/60. Therefore, to load Sounds from
Pa80/60 disks, you must accomplish one of the following opera-
tions:
• Either rename the "PROGRAM" folder "SOUND" (by
using a personal computer) before loading a ".SET" folder;
or
• First load the ".SET" folder, then separately load the ".PCG"
file from the "PROGRAM" folder.