Korg PA1X User Manual page 362

358 Effects
ER/Delay
a: Polarity, b: Threshold, b: Offset, c: Attack, d: Release
The "Offset" parameter specifies the value for the "Control Tar-
get" parameter (that is set to None), expressed as the ratio rela-
tive to the parameter value (the "Wet/Dry" value with "Control
Target"=Out, or the "Feedback" value with "Control Tar-
get"=FB).
When "Polarity" is positive, the "Control Target" value is
obtained by multiplying the parameter value by the "Offset"
value (if the input level is below the threshold), or equals the
parameter value if the input level exceeds the threshold.
When "Polarity" is negative, Control Target value equals the
parameter value if the input level is below the threshold, or is
obtained by multiplying the parameter value by the "Offset"
value if the level exceeds the threshold.
The "Attack" and "Release" parameters specify attack time and
release time of delay level control.
Level
Dry
Envelope
Attack
Wet (Ducking Delay)
Control Target=Out
Polarity= (–)
Wet
Control Target=Out
Polarity= (+)
048: Autopan Delay
This stereo delay effect pans the delay sound left and right using
the LFO.
Stereo In - Stereo Out
Left
High Damp Low Damp
Delay
Feedback
Delay
High Damp Low Damp
Right
LFO: Tri / Sin LFO Shape
Dynamic Delay
Threshold
Release
Delay Time
Time
Wet / Dry
Pan
Depth
Pan
Wet / Dry
LFO Phase
L Delay Time [msec]
Sets the delay time for the left channel
a
L Feedback
Sets the feedback amount for the left channel
R Delay Time [msec]
Sets the delay time for the right channel
b
R Feedback
Sets the feedback amount for the right channel
High Damp [%]
Sets the damping amount in the high range
c
Low Damp [%]
Sets the damping amount in the low range
LFO Waveform
Selects LFO Waveform
d
LFO Shape
Determines how much the LFO waveform is changed
LFO Phase [degree]
e
Sets the LFO phase difference between the left and right
Panning Frequency [Hz]
f
Sets the panning speed
Panning Depth
Sets the panning width
Src
g
Selects the modulation source for the panning width
Amt
Set the modulation amount of the panning width
Wet/Dry
Table , "Sets the balance between the effect and dry sounds," on page 330
Src
h
Table , "Selects the modulation source of the effect balance," on page 330
Amt
Table , "Sets the modulation amount of the effect bal-
ance," on page 330
0.0...680.0msec
–100...+100
0.0...680.0msec
–100...+100
0...100%
☞
Fx:043
0...100%
☞
Fx:043
Triangle, Sine
–100...+100
☞
Fx:020
–180...+180
☞
Fx:034
0.02...20.00Hz
0...100
Off...Tempo
–100...+100
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100