Korg PA1X User Manual page 413

Pa1X
1.
Turn the instrument upside down, and remove the eight
screws (a), to open the cover (b) and gain access to the option
compartment.
Note: Block any possible access to the inside of the instru-
ment (for example, the openings of the nearby RAM expan-
sion slots) during installation to prevent any items from
falling inside. In the event something does fall into the instru-
ment, please immediately contact your nearest Service Cen-
ter.
2.
As you face the option compartment opening, locate the area
reserved for the MP3 board, i.e., the one with the four small
vertical spacers, the MP3 audio cable (c) and the video cable
(d). Please note how the video cable (d) is fastened by two
clamps (f) to two of the spacers, by means of two M3 screws
(D). Remove both screws (D), taking care not to remove the
two clamps from their position, and unfasten the audio cable
(c) from the clamp (e).
3.
Insert the MP3 board (C) over the four spacers, with the compo-
nents on the upper side (as shown in the diagram). Secure it to
the spacers by using the four M3 screws (D). Connect the termi-
nal lug of the cable (c) to the corresponding connector on the
MP3 board, by folding the cable as shown in the diagram.
4.
Close and secure the compartment cover by reversing the
procedure described in step 1.
Installing the MP3 Board (EXBP-MP3)
a
a
b
a
a
d
D+f
D
D
409
Installation
a
a
a
a
c e
D+f
D
C
c
D