Korg PA1X User Manual page 174

170 Sequencer operating mode
Record mode: Multitrack Sequencer page
Overwrite The newly recorded events will replace any exist-
ing events.
Auto Punch Recording will automatically begin at the "Start"
position, and stop at the "End" position.
Note: The Auto Punch function will not work on an
empty Song. At least one track must already be
recorded.
PedalPunch Recording will begin when pressing a pedal set to
the "Punch In/Out" function, and will finish
when pressing the same pedal again.
Note: The Pedal Punch function will not work on
an empty Song. At least one track must already be
recorded.
Free memory
Remaining memory available for recording.
Resolution
Use this parameter to set the quantization during record-
ing. Quantization is a way of correcting timing errors;
notes played too soon or too later are moved to the nearest
axis of a rhythmic "grid", set with this parameter, thus
playing perfectly in time.
High No quantization applied.
(1/32)... (1/8)
Grid resolution, in musical values. For
example, when you select 1/16, all notes are
moved to the nearest 1/16 division. When
you select 1/8, all notes are moved to the
nearest 1/8 division
No quanti-
zation
1/16
1/8
Start/End
Start and End locators. These parameters area available only
when the "Auto Punch" recording mode is selected. They set the
starting and ending points of the Punch recording.
Metro (Metronome)
This is the metronome heard during recording.
Off No metronome click will be heard during record-
ing. A one-bar precount will be played before
starting recording.
On1 Metronome on, with a one-bar precount before
starting recording.
On2 Metronome on, with a two-bar precount before
starting recording.
.
Tempo
Select this parameter, and use the TEMPO/VALUE controls to
set the tempo.
Note: You can always change the Tempo, when other parameters
are selected, by keeping the SHIFT button pressed, and rotating the
DIAL.
Note: The tempo is always recorded in overwrite mode (old data is
replaced by the new data).
Meter
This is the basic meter (or time signature) of the Song. You can
edit this parameter only when the Song is empty, i.e., before you
begin recording anything. To insert a meter change in the middle
of the Song, use the "Insert Measure" function (see page 185).
Tempo (Tempo mode)
This parameter sets the way tempo events are read or recorded.
Manual Manual reading. The latest manual Tempo setting
(made using the TEMPO/VALUE controls) is
considered the current Tempo value. No Tempo
change events will be recorded. This is very useful
to record the Song much slower than its actual
Tempo.
Auto Auto reading. The Sequencer plays back all
recorded Tempo events. No Tempo change events
are recorded.
Record All Tempo changes made during recording will be
recorded to the Master Track.
Selected track info area
This line lets you see the Sound assigned to the selected track.
See "Selected track info area" on page 167 for more information.
Sounds area
This area lets you see Sounds and octave transposition for the
eight tracks currently displayed. See "Sounds area" on page 167
for more information.
Track volume/status area
This area is where you can set the volume of each Song track,
and change track status. See "Track volume/status area" on
page 167.
Track status icons
Play/mute/record status of the current track. Select the track,
then press this area to change its status.
Play status. The track can be heard.
Mute status. The track cannot be heard.
Record status. After pressing
start recording, the track will receive notes from
the keyboard and the MIDI IN connector.
(PLAY/STOP) to