TOHATSU MFS 4C Owner's Manual page 57

5. Tighten the oil drain screw with apply-
ing oil on the sealing surface of screw.
(Use new oil drain washer)
Oil drain screw specified torque
18N·m (13 ft lb, 1.8 kgf
·
ENON00028-A
Note
If a torque-wrench is not available when you
are fitting a oil filter, a good estimate of the
correct torque is 3/4 to 1 a turn past finger-
tight. Have the oil filter adjusted to the cor-
rect torque as soon as possible with a
torque-wrench.
6. Reset the engine in a vertical position.
7. Repeat 3 to 7 procedures two or three
times to drain the oil completely.
8. Remove the top cowl and the oil filler
cap.
9. Fill the engine through filler port with
recommended oil (see chart below) to
the middle of dipstick mark.
10. Tighten the oil filler cap.
1
1. Oil filler cap (Dipstick)
m)
·
ENOF00446-0
INSPECTION AND MAINTENANCE
1
2
1. Upper limit (Max.)
2. Lower limit (Min.)
ENON00920-0
Note
Use only recommended engine oil (See
page 12)
10W−40
10W−30
-30 -20 -10 0 10
-22 -4 14 32 50
Oil volume needed for complete oil replace-
ment
450 mL (15.2 fl.oz.)
ENOW00925-0
CAUTION
Wipe off engine oil well immediately if
spilled and dispose of it in accordance with
local fire prevention and environment pro-
tection regulations.
ENON00031-0
Note
If any amount of water is found in engine
oil, making it milky white, consult dealer.
If engine oil is contaminated with fuel,
emitting strong fuel smell, consult dealer.
55
ENOF00447-0
20 30 40 ˚C
68 86 96 ˚F
ENOF00208-0
10