TOHATSU MFS 4C Owner's Manual page 40

38
ENGINE OPERATION
Tiller handle type
1. Turn the throttle grip to the slow posi-
tion.
1. Throttle grip
2. Put the shift lever in the Neutral posi-
tion.
Run the engine for 2-3 minutes at
idling speed for cooling down if it has
been running at full speed.
7
3. Push the stop switch.
ENOW00869-0
After stopping the engine:
Close the air vent screw on the fuel tank
cap.
Disconnect the fuel connector of the
engine and the fuel tank.
Disconnect the battery cord, after each
use.
1
ENOF01107-0
ENOF00439 B ENOF00210 0
WARNING
Emergency engine stopping
Remove stop switch lock to stop the
engine.
1
1. Hock
2. Stop switch lock
3. Stop switch
ENOM00910-0
Spare emergency stop switch lock
A spare emergency stop switch lock is
provided in the tool bag.
When used as described, the emergency
stop switch clip and emergency stop
switch lanyard system stops the engine if
the operator falls away from the controls.
When an operator falls into water, be sure
to use emergency stop switch lock of the
spare.
Be sure to confirm the spare stop switch
lock is in the tool bag before begin to oper-
ate.
2
3
ENOF00210-0 ENOF00439-0
ENOF00891-0