Interpreting Error Messages On The Hp Advancestack Router 200 Series; General Procedure For Self-Test Failures - HP Series 200 Installation Manual

Troubleshooting

Interpreting ERROR Messages on the HP AdvanceStack Router 200 Series

Interpreting ERROR Messages on
the HP AdvanceStack Router 200
Series
N o t e
This section applies to the following routers:
HP Router PR
HP Router FR
HP Router TFR

General Procedure for Self-Test Failures

If the router has a hardware problem that prevents either normal opera-
tion or display of error conditions, then the problem is indicated by the
appropriate LED patterns described in table 3-1, ''LED Error Patterns
During Initialization'' on page 3-4. Otherwise, the console displays the
appropriate error message along with instructions for further action:
7, MK5025 Test
ERROR: MK5025 failed interrupt test, errcode = 00000001
Error number
SELFTEST FAILURE
Error message
A hardware problem was detected while running selftest.
To enter the selftest monitor, press 's'. To attempt to
Error procedure load operating code, press any other key.
If no key is pressed after 10 seconds, an attempt will
be made to load operating code.
3-6