HP Series 200 Installation Manual page 32

Installation
Phase 3: Prepare the Router Hardware
Figure 1-20. Example of Power and Self-Test LED Positions for Double-Height Models
3. After the Self-test LED turns off:
• The port status LEDs for the network interfaces (WAN, 802.3
• The console, if installed, will display either the following line of
N o t e
The remainder of this procedure assumes that a console is connected to
the router's console port, either directly or through a modem.
1-24
Power and
Self-Test
LEDs
27290A R outer BR
Ethernet/802.3 Po rt 1
Enabled
BNC AUI
Co nsole Po rt
RS-2 32
Pwr
See Ma nual
Ethernet, etc.) will indicate the current operating state of each
interface on the router. (If you need to interpret the LEDs at this
time, refer to ''Meanings of Port Status LEDs'' on page 2-9.)
text on your console's display:
Waiting for speed sense.
or a string of random characters of about the same length as the
preceding line.
Ethernet/802.3 Po rt 2 Ethernet/802.3 Po rt 3
Enabled Enabled
BNC AUI BNC AUI
FDDI Por t
Optical By pass
MIC A MIC B
MIC Por ts
A
Enabled
B
SO PI PO SI
Ethernet/802.3 Po rt 4
Enabled
BNC AUI
Ass embly No . 27 290-60001