Interpreting Led Error Patterns - HP J2600A Installation Manual

Advancestack
Hide thumbs Also See for J2600A:
Table of Contents

Advertisement

Troubleshooting

Interpreting LED Error Patterns

Interpreting LED Error Patterns
Whenever the hub is powered on or reset, and whenever the router
module is reset (page 3-5) or cleared (page 3-7), a self-test of the router
is run.
If the self-test was initiated by powering on or resetting the hub, this
self-test can last up to 30 seconds if the hub had previously been
powered on with the SNMP module installed, or up to 60 seconds if the
hub had not previously been powered on with the SNMP module
installed. During this time, the Fault LED on the front of the hub is
turned on, the Exp Slot LED (labeled "AdvSlot" on some HP Advance-
Stack hubs) flashes slowly, and the Router Self-test LED on the router
module's cover plate is turned on. If the hub's Fault LED remains on and
the Exp Slot LED continues flashing for more than 60 seconds, a failure
has been found during the self-test.
If the self-test was initiated by resetting or clearing the router module,
the self-test lasts about 18 seconds; during this time, the Router Self-test
LED on the router module's cover plate is turned on. If this LED remains
on for more than about 18 seconds, a failure has been found during the
self-test.
When a failure has been found during the self-test, check the LEDs on
the router module's cover plate (see figure 3-1) to determine the cause
of the failure. The error conditions indicated by these LEDs are shown
in table 4-1 on page 4-4.
During router operation (that is, after the self-test has been passed), the
Fault LED on the front of the hub is normally off, and the Exp Slot LED
(labeled "AdvSlot" on some HP AdvanceStack hubs) is normally on. If a
failure is found during router operation, the Fault LED on the front of
the hub turns on and the Exp Slot LED flashes slowly. When this
happens, check the LEDs on the router module's cover plate (see figure
3-1) to determine the cause of the failure. The error conditions indicated
by these LEDs are shown in table 4-2 on page 4-5.
4-3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

J2602aJ2601a

Table of Contents