HP Series 200 Installation Manual page 83

Troubleshooting
Diagnostic Tests
N o t e
If pressing [Return] after the speed sensing text gets the prompt:
router console>
instead of the copyright screen or Main menu, then the product
operating code has been lost. Contact your HPdealer or service
provider for further assistance.
Adjust Baud Rate:
1. Temporarily set the baud rate of the terminal or terminal emulator to
9600, if available, or to the slowest setting.
2. Detach the console cable from the router.
3. Reattach the console cable to the router.
4. Look for the line of text on your console that indicates waiting for
speed sensing; then press [Return] to display the copyright screen or
the Main menu screen. If neither of these screens appears, press
[Return] again. If pressing [Return] four or five times does not display
either the copyright or Main menu screen, then ensure that you are
using the correct console cable. (Refer to "HP Cables" on page A-3.)
If the cable is correct, then repeat this procedure for each other
baud rate available for your terminal until you find a rate that gives
you a successful connection. If you cannot establish a successful
connection, go on to ''Reset the Terminal'', below.
Reset the Terminal:
1. Switch the terminal or PC's power off and then on once.
2. Make sure the configuration for your terminal or emulation matches
the requirements listed under "Connect a console" (page 1-10).
3. Look for the line of text on your console that indicates waiting for
speed sensing; then press [Return] to display the copyright screen or
the Main menu screen. If neither of these screens appears, press
[Return] again. If pressing [Return] four or five times does not display
either the copyright or Main menu screen, then go on to ''Test
Router's Console Port'', below.
3-13