HP Series 200 Installation Manual page 29

Installation
Phase 3: Prepare the Router Hardware
Connecting a WAN to the WAN Interface
The RS-232, V.35, X.21, or RS-422/449 cable for the 62-pin connector de-
termines which interface standard is used on this port.
WAN link terminating
equipment (such as a
modem or DSU/CSU)
Circuit from WAN
service provider
Figure 1-18. Connecting a WAN Interface
1. Attach the male end of the cable to the router's WAN port.
Hand-tighten the screws attached to the cable connector.
2. Attach the other end of the cable to the WAN link terminating
equipment.
N o t e
If any port has no network attached, the port's Net Fail LED goes on
after the router starts.
WAN port for RS-232, V.24/V.28, V.35,
X.21, RS-422/RS-449, V.36 interfaces
1-21