HP Series 200 Installation Manual page 39

Installation
Phase 4: Initialize and Verify the Router
Figure 1-25. The Default NCL Prompt
2. Boot the router (with your new configuration) by typing boot at the
NCL prompt and pressing [Return].
DEFAULT_CONFIG: boot [Return]
3. If your router does not have a Manager password, go to step 4. But if
the router has a previously set Manager password, you must enter
the password before booting can proceed. In this case, the console
prompts you to enter the password:
Enter current manager password:
Type your Manager password and press [Return]. (If you've forgotten
the password and need to clear it, refer to ''To Clear the Manager and
User Passwords'' on page 2-16.)
4. After you enter the Boot command (and enter a password, if
required), the following message prompts you verify that you want to
boot the router:
Do you want to reboot the system? [y/n]
Press [Y] to commence the reboot operation.
NCL prompt
1-31