Recoverable Self-Test Failures - HP Series 200 Installation Manual

Troubleshooting
Interpreting ERROR Messages on the HP AdvanceStack Router 200 Series
Press [Return] or wait 10 seconds to attempt to load the router's operating
code.
N o t e
If a qualified support person is available to operate the selftest monitor,
press [s] to enter the selftest monitor. Otherwise, do as described above
to attempt to load the operating code.
In all cases of displayed ERROR messages, take additional action as
indicated below:
If the operating code is successfully loaded, you can continue
normal router operation. However, you should record the initial
failure information and call for service from your HP dealer or
service provider. It may be necessary to download new operating
code to your router. For more information, refer to ''Recoverable
Self-Test Failures'', below.
If the operating code does not successfully load, record the failure
information and call for service from your HP dealer or service
provider. It may be necessary to replace your router.

Recoverable Self-Test Failures

The following two error messages indicate a problem in the router's
FLASH memory that may be corrected by cycling the power. If, after the
power is cycled, the problem persists, then it may be corrected by down-
loading new operating code. In this case, contact your HP dealer or
service provider.
ERROR: Erasure ERROR, block #
ERROR: Programming ERROR, block #
The following three error messages indicate a problem in the router's
FLASH memory that may be corrected by downloading new operating
code. For further assistance, contact your Hewlett-Packard repre-
sentative.
ERROR: Incorrect CRC in FLASH
ERROR: Invalid size field in FLASH
ERROR: Illegal FLASH ID, byte #, got XXXX,
expected YYYY
3-7