HP Series 200 Installation Manual page 49

Installation
Phase 4: Initialize and Verify the Router
Examine the Bridging and Routing Tables
Use the NCL Rget commands to verify that the bridging and/or routing
tables represent the expected network topology. Note that Rget
commands are SNMP-based. IP routing or IP host-only service must be
enabled to use the Rget commands.
N o t e
You can use the Quick Configuration utility to activate host-only service.
Most HP router models have all of the Rget commands listed here.
However, not all commands are available on every router.
(This section provides an overview of the Rget commands. For more
information on these commands, refer to the Operator's Reference.)
RGETB: Use the Rgetb command to display the bridge forwarding
and filtering table for this node. Verify that the bridging service is
learning addresses. Verify proper configuration of source or
destination address filters.
RGETR: Use the Rgetr command to display the IP routing table for
this node. Verify that entries exist for all IP subnetworks represented
in the network map. Check the next-hop entries to determine the
route that IP packets will take to each destination subnet. Verify the
number of hops to these subnets; a very large hop count may
indicate that the route is invalid (type field I).
RGETIR: Use the Rgetir command to display the IPX routing table
for this node. Verify that entries exist for all IPX networks
represented in the network map. Check the next-hop entries to
determine the route XNS packets will take to each destination
network. Verify the number of hops to these networks; a very large
hop count may indicate that the route is invalid (type field I).
RGETIS: Use the Rgetis command to display the IPX server table for
this node. Using your IPX network map, verify that the router has
learned about all IPX servers. Note that if IPX SAP filters are being
used in the network, your router may be restricted from learning
about some servers. Also note that HP devices may be listed in the
SAP table (used by HP OpenView network management during
autodiscovery).
1-41