HP Series 200 Installation Manual page 84

Hide thumbs Also See for Series 200:
Table of Contents

Advertisement

Troubleshooting
Diagnostic Tests
Test Router's Console Port:
1. Detach the console cable from the router.
2. Attach the console port's loopback connector to the router. (Refer to
"Loopback Connectors" on page A-20).
3. Press the Reset button on the back of the router.
C a u t i o n
Resetting the router causes bridging and routing tables to be reset.
4. If the Fault LED lights within one to three minutes and while the
Self-test LED is still lit, the router is faulty and must be replaced.
5. To resume after testing, remove the loopback connector and
reconnect the console cable to the console port. Look for the line of
text on your console that indicates waiting for speed sensing; then
press [Return] to display the copyright screen or the Main menu screen.
If neither of these screens appears, press [Return] again. If pressing
[Return] four or five times does not display either the copyright or Main
menu screen, then go on to ''Check the Configuration'', below.
Check the Configuration
If none of the above procedures provides console access, and you
suspect that a corrupted configuration rather than the terminal connec-
tion is a possible cause, then you may need to clear the configuration.
(Refer "To Clear the Router" on page 2-17.)
3-14

Advertisement

Table of Contents
loading

This manual is also suitable for:

Series 400

Table of Contents