HP Series 200 Installation Manual page 21

Installation
Phase 3: Prepare the Router Hardware
1. Slide the AUI retainer (included) onto the connector posts on a
transceiver (also called a "MAU") that corresponds to your type of
network cabling, or on an AUI cable that is attached to a transceiver
(whichever will attach directly to the router).
Transceiver or
AUI cable con-
nector
Figure 1-10. Installing the AUI Retainer
2. Plug the transceiver or cable into the Ethernet/802.3 port on the
router.
3. Secure the retainer and the transceiver or cable to the router with
the retainer's screws.
4. Connect the network cable to the transceiver.
If your router's LAN port(s) have both an AUI interface and a BNC
interface, refer to the note on page 1-11
AUI retainer
AUI LAN port on router
Connector post
1-13