Hp 5061-2556 Back-To-Back Test Cable For 62-Pin Connector-Minimum Pin-Outs - HP Series 200 Installation Manual

Cables and Connectors
Cable and Connector Pin-Outs
HP 5061-2556 Back-to-Back Test Cable for
62-Pin Connector—Minimum Pin-Outs
For a description of the use of this test cable, see page A-13 above. The
WAN port on one router must have the Point to Point Address config-
ured to DCE and the WAN port on the other router must have it config-
ured to DTE. In addition, one must have the Clock Source parameter
configured to External, and the other must have it configured to Internal.
62-pin male
SDA
SDB
RDA
RDB
RSA
RSB
CSA
CSB
TRA
TRB
DMA
RRA
DMB
RRB
TTA
TTB
STA
RTA
STB
RTB
GND
shield
A-14
62-pin male
17 1 RDA
38 22 RDB
1 17 SDA
22 38 SDB
15 4 CSA
36 25 CSB
4 15 RSA
25 36 RSB
16 5 DMA
6 RRA
37 26 DMB
27 RRB
5 16 TRA
6
26 37 TRB
27
14 2 STA
3 RTA
35 23 STB
24 RTB
2 14 TTA
3
23 35 TTB
35
9 9 GND
10 10
30 30
32 32
shield
Note: On the HP Router PR, FR, and TFR, Clock
Source is automatically configured to the
proper setting (Internal or External) when
using the HP 5061-2556 test cable. On other
models, you must use the Configuration Editor
to change the Clock Source setting.