Hp 5061-2557 Back-To-Back Test Cable For 62-Pin Connector-Minimum Pin-Outs - HP Series 200 Installation Manual

Cables and Connectors
Cable and Connector Pin-Outs
N o t e
In the cable, each of the differential signal pairs (SDA and SDB, RDA
and RDB) and so on, must be twisted pairs of wire.
HP 5061-2557 Back-to-Back Test Cable for
62-Pin Connector—Minimum Pin-Outs
For a description of the use of this test cable, see page A-13 above. The
WAN port on one router must have the Point to Point Address config-
ured to DCE and the WAN port on the other router must have it config-
ured to DTE. In addition, this router must have Clock Source configured
to Internal, and the HP Router CR must have it configured to External.
For the pinouts of this cable, turn the page.
A-15