Tools Required For Service - Lexmark CX310 Service Manual

•
Hard disk memory—Some devices have a hard disk drive installed. The printer hard disk is designed for device-
specific functionality and cannot be used for long term storage for data that is not print-related. The hard disk
does not provide the capability for users to extract information, create folders, create disk or network file shares,
or transfer FTP information directly from a client device. The hard disk can retain buffered user data from
complex print jobs, as well as form data and font data.
To erase volatile memory, turn off the printer.
To erase non-volatile memory, see the menu item under
To erase the printer hard disk, see the menu item under
The following parts are capable of storing memory:
•
printer control panel
• UICC (User Interface Controller Card)
•
controller board
•
optional hard drives
Note: The printer control panel and controller board contain NVRAM.
2
After removing the old part, it must be returned to your next level of support.

Tools required for service

•
Flat-blade screwdrivers, various sizes
•
#1 Phillips screwdriver, magnetic
•
#2 Phillips screwdriver, magnetic
•
#2 Phillips screwdriver, magnetic short-blade
•
7/32 inch (5.5 mm) open-end wrench
•
7.0 mm nut driver
•
Needle‑nose pliers
•
Diagonal side cutters
•
Spring hook
•
Feeler gauges
•
Analog or digital multimeter
•
Parallel wrap plug 1319128
•
Twinax/serial debug cable 1381963
•
Coax/serial debug cable 1381964
•
Flash light (optional)
•
3 mm hex wrench
"Configuration menu" on page 216
"Configuration menu" on page 216
General information
33
7527
pertaining to this.
pertaining to this.