d
Align the duplex aligner guide so that the gears (H) mesh on the left.
e
Replace the eight screws in the duplex aligner.
f
Close the front door.
Fuser assembly removal
1
Remove the right cover assembly. See
2
Remove the left cover assembly. See
3
Disconnect the two‑wire fuser cable (A) from the LVPS.
4
Position the fuser cable so that it can be pulled through from the front of the printer, and guide the cable through
to the front.
Warning—Potential Damage: Be careful not to damage the cable by pulling too hard or cutting the cable
insulation.
"Right cover assembly removal" on page
"Left cover assembly removal" on page
Repair information
287
256.
246.
7527