4
Disconnect the waste toner bottle contact block (B) from the controller board.
5
Remove the waste toner bottle contact block.
Front removals
Front cover assembly removal
1
Remove the media tray.
2
Open the front cover.
3
Remove the front middle cover (optional). See
4
Remove the five screws (A) from the cable cover.
5
Remove the cable cover.
6
Remove the screw (B) securing the right restraining strap to the front cover.
Note: Support the door with one hand after removing the screw holding the restraining strap. This is the longest
screw of the eight. The two flat‑head Phillips screws are used in the door hinge.
"Front middle cover removal" on page
Repair information
273
7527
275.