Table of Contents
Advertisement
CHAPTER 2: Setting Up Your Server
Starting your server
When you connect peripheral devices to
the server, make sure that your server and
devices are turned off and the power
cords are unplugged.
18
Before you start your server for the first time:
Make sure that the server and monitor are plugged into a power outlet
■
or surge protector and that the surge protector (if you are using one) is
turned on.
Make sure that all cables are connected securely to the correct ports and
Caution
■
jacks on the back of the server.
To start the server:
Turn on any peripheral devices connected to the server.
1
Press the power button (1), the Power LED (2) lights.
2
If nothing happens when you press the power button:
■
■
■
The first time you turn on the server, any pre-installed operating system
3
may begin asking you for configuration settings. See your operating
system's documentation for instructions on configuring advanced settings
for your specific network.
Make sure that the power cable(s) is plugged in securely and that
your surge protector (if you are using one) is plugged in and turned
on.
Make sure that the monitor is connected to the server, plugged into
the power outlet or surge protector, and turned on. You may also
need to adjust the monitor's brightness and contrast controls.
If you cannot find the cause of the power loss, contact Gateway
Customer Care. For more information, see
page
9.
www.gateway.com
"Getting Help" on
Advertisement
Table of Contents
Troubleshooting
