Assembly Of Ej Frame Assy; Checking Of Ej Frame Assy - Epson Stylus Photo RX700 Service Manual

EPSON Stylus Photo RX900

4.4.22.1 Assembly of EJ Frame Assy

C A U T I O N
When installing the EJ frame torsion springs, take care not to
bend the spring catches of the printer frame.
Lubrication is necessary. Refer to the following section and
lubricate the specified points:
Lubrication of EJ Frame Assy (p.160)
1. Apply grease to the specified points.
2. Install the Right and Left Racks and the Right and Left EJ Links on the printer frame.
3. Turn over the block levers (x2) to the front, and insert the right shank of the EJ Frame
Assy into the groove in the Right Rack and the guide area of the Right EJ Link.
(See Figure 4-76)
4. Through the groove in the Left Rack, insert the left shank of the EJ Frame Assy into
the guide area of the Left EJ Link.
5. Install the Right and Left EJ Frame Release Guides.
6. Install the right and left EJ frame torsion springs.

4.4.22.2 Checking of EJ Frame Assy

After assembling the EJ Frame Assy, check the following conditions for properness.
(See Figure 4-77)
When the EJ Frame Assy is moved back and forth, the Right and Left EJ Links
move together.
The right and left block levers have been turned over to the front
Disassembly and Assembly
Install the shank of the EJ Frame Assy
through the groove in the Left Rack
~ Right side ~
~ Left side ~
Disassembly and Assembly of Major Parts of Printer
Figure 4-76. Installing the EJ Frame Assy
EJ Frame Assy ~ Inside the frame ~
Right EJ Link
The right and left block levers must be
turned over to the front
Left EJ Link
Figure 4-77. Checking the EJ Frame Assy
Revision A
Turn over the right
and left block levers to
the front and install
Block lever
131