Download Print this page
Epson Stylus Photo RX600 How To Copy And Print
Hide thumbs Also See for Stylus Photo RX600:

Advertisement

CPD-17417
4048049-00

Advertisement

loading

Summary of Contents for Epson Stylus Photo RX600

  • Page 1 CPD-17417 4048049-00...
  • Page 2 Start Here sheet. Epson and Epson Stylus are registered trademarks and PRINT Image Matching, and the PRINT Image Matching logo are trademarks of Seiko Epson Corporation. BorderFree is a registered trademark of Epson America, Inc.
  • Page 3: Copying A Photo

    Copying a Photo Here’s how to make a copy of a 4 × 6-inch photo using Epson Premium Glossy Photo Paper: Press the button to turn on the Stylus Photo RX600. Open the output tray. Output tray Flip the feeder guard forward.
  • Page 4 Press the sides of the left edge guide together and slide it against the paper (but not too tightly). Make sure the paper is under the tab on the left edge guide. Flip the feeder guard back over the paper. Open the scanner lid.
  • Page 5 Place your 4 × 6-inch photo face-down on the glass, in the upper left corner. Move your photo about 0.1 inch from the top and side edge so your entire photo is scanned. 0.1 in 0.1 in Move the photo in about 0.1 inch from the edges Close the scanner lid.
  • Page 6 Use the u and d buttons to choose , then use Copy Layout the l and r buttons to change the setting to BorderFree Press the button. Choose the following settings: : the number of prints Copies Reduce/Enlarge AutoFitPage : leave this setting blank (if it is accidently Zoom In/Out changed, reset the setting to...
  • Page 7: Printing Photos From A Memory Card

    Open the output tray. Output tray Flip the feeder guard forward. Insert a sheet of 4 × 6-inch Epson Premium Glossy Photo Paper short edge first against the right edge of the sheet feeder, under the tab, with the shiny side up.
  • Page 8 Press the sides of the left edge guide together and slide it against the paper (but not too tightly). Make sure the paper is under the tab on the left edge guide. Flip the feeder guard back over the paper. Press the button to set the RX600 to Memory Memory Card...
  • Page 9 Open the memory card slot cover. Insert your memory card into the correct slot. Be careful not to force it in (it won’t go in all the way). Note: Do not insert more than one card. ™ ® ™ CompactFlash Memory Stick SmartMedia ™...
  • Page 10 If the light doesn’t turn green, or if you see the message on the LCD screen, the memory card. Operation Canceled card may be inserted incorrectly or may not be supported. Note: To remove the card, first make sure your RX600 is not printing and the memory card light is not flashing.
  • Page 11 Make sure the cable is connected to the (transparency unit) interface connector. (If it is not connected, turn off the RX600, connect the cable, then turn the RX600 back on.) Press the P button to turn on the Stylus Photo RX600. Open the output tray. Output tray...
  • Page 12 Flip the feeder guard forward. Insert a sheet of 4 × 6-inch Epson Premium Glossy Photo Paper short edge first against the right edge of the sheet feeder, under the tab, with the shiny side up. Press the sides of the left edge guide together and slide it against the paper (but not too tightly).
  • Page 13 Flip the feeder guard back over the paper. Open the scanner lid.
  • Page 14 Remove the document mat from the scanner lid by pulling the handle to the left. Carefully lift the film holder out of the scanner lid by pulling it straight up. Lift off the filmstrip cover.
  • Page 15 Slide the strip of film into the film holder, with the duller (emulsion) side up. Reinstall the filmstrip cover over the strip of film (it should snap into place). Press it around the edges to make sure it is closed. Place the film holder on the document table, as shown.
  • Page 16 Press the button to set the RX600 to Film Print mode. Film Print Film Print button Use the u and d buttons to choose , then press Basic Print 4 x 6" button. (For advanced printing options, see your User’s Guide.) Use the l and r buttons to choose , then...
  • Page 17 After the film is scanned, use the l and r buttons to scroll through and select a photo, then use the u and d buttons to choose the number of copies to print of that photo. Press the x button to print a color photo or press the Color button to print a black and white photo.
  • Page 18 What Else You Can Do There is much more you can do with your Stylus Photo RX600. You’ll find instructions for all of these features and more in your User’s Guide. Print and scan from your computer. Also use your...
  • Page 19 RX600 using the optional Bluetooth Photo Print adapter. If you have a PictBridge - or USB Direct ® Print-enabled camera, you can connect it to the Stylus Photo RX600 to print photos right from your camera.
  • Page 20 Printed in XXXXXX XX.XX-XX...