Eject Frame Assy - Epson Stylus Photo RX 560 Service Manual

EPSON Stylus PHOTO RX560/580/590

4.5.7 Eject Frame Assy

1. Remove the Printer Mechanism (p.55)
2. Remove the Head FFC from the Front Frame. (Fig. 4-74)
3. Release the harness of the CD-R sensor from the hook of the Eject Frame.
(Fig. 4-75)
4. Remove the screw securing the Cable Holder Frame.
5. Remove the right and left screws (x2) securing the Front Frame, and remove the
Front Frame from the printer body.
6. Remove the Eject Frame Assy from the printer body. (Fig. 4-76)
Before installing the Eject Frame, install the Left EJ Frame
Spring (longer), and the Right EJ Frame Spring (shorter)
temporarily, in the respective positions shown below on the
Eject Frame. After installing the Front Frame, move the Right
EJ Frame Spring to the spring support.
~Left side~
Left EJ Frame Spring
Fit the shaft holders (left and right) on the underside of the Eject
Frame onto the Paper Eject Roller Shaft. (Fig. 4-76)
After installing the Front Frame, confirm the engagement of the
projections (x2), and then tighten the screws in the specified order.
(Fig. 4-75)
Lubrication is necessary. Refer to the following section and
lubricate the specified points:
Lubrication of Front Frame (p.90)
After installing the Cable Holder Frame, confirm the engagement
of the projection, and then tighten the screw. (Fig. 4-75)
After installing the Head FFC as shown, move the carriage several
times and confirm that the FFC is free from undue tension or
excessive allowance. (Fig. 4-74)
Disassembly and Assembly
~Right side~
Right EJ Frame Spring
~Temporarily~
Disassembly and Assembly of Major Parts of Printer
Acetate Tape (18x50mm)
Front Frame
Acetate Tape (30x40mm)
Locate it on the folded part
Figure 4-74. Removing the Head FFC
Cable Holder Frame
C.B.S-TITE 3x6
·
Torque : 0.8±0.1N m
Projection
C.B.S-TITE 3x6 (x2)
Torque : 0.8±0.1N
Projection
2
Front Frame
Release the harness
Figure 4-75. Removing the Front Frame
Shaft holder
Eject Frame Assy
Figure 4-76. Removing the Eject Frame Assy
Revision A
Head FFC
1±1 mm
·
m
1
Projection
Shaft holder
69