Rear Paper Guide Assy; Chapter 4 Disassembly And Assembly - Epson Stylus Photo RX700 Service Manual

EPSON Stylus Photo RX900

4.4.10 Rear Paper Guide Assy

1. Remove the Printer Mechanism. (p.107)
2. Remove the screws (x2) securing the Paper Feed Lower Cover at the bottom of the
printer. (See Figure 4-50)
3. Disengage the hooks (x2) on the PF Motor side, and remove the Paper Feed Lower
Cover from the printer frame.
4. Disengage the hook on the PF Motor side, and remove the Rear Paper Guide Assy.
5. Remove the screw on the Projection side, and remove the Paper Guide Bank
Separation from the Paper Feed Lower Cover.
Lubrication is necessary. Refer to the following section and
lubricate the specified points:
Lubrication of Driven Pulley Assy (p.154)
Install the Paper Guide Bank Separation, so that the projection
of the Paper Feed Lower Cover enters the hole in the Paper
Guide Bank Separation. (See Figure 4-51)
Disassembly and Assembly
Paper Feed Lower Cover
C.B.P-Tite 3x6 F/ZN-3C
給紙下カバー
Disassembly and Assembly of Major Parts of Printer
Rear Paper Guide Assy
⋅
Torque: 0.6 ± 0.1N m
C.B.S-Tite 3x6 F/ZN-3C
Figure 4-50. Removing the Rear Paper Guide Assy
Paper Feed Lower Cover
Paper Guide Bank Separation
Figure 4-51. Paper Guide Bank Separation
Revision A
Hook
⋅
Torque: 0.8 ± 0.1N m
Projection
114