Epson Stylus Photo RX700 Service Manual page 93

EPSON Stylus Photo RX900
Take care not to confuse the orientation of the terminal side of
the FFC when connecting the FFC to the Printhead.
After installing the CR Weight, form the FFC of the CR
Encoder Board as shown at right. (See Figure 4-21)
C H E C K
When installing the Valve Assy, place the Head FFCs between the
P O I N T
Ink Tube Assy and the Tube Guide, and connect them to the Valve
Assy. In doing so, to facilitate your work, you are advised to place a
sheet of paper bent into a shape of mountain over the FFCs and
remove it after installing the Valve Assy. (See Figure 4-22)
A D J U S T M E N T
Adjustments are required. When the Printhead has been replaced
R E Q U I R E D
with a new one, refer to the following section and perform the
necessary adjustments. Note down the head ID before installing the
Printhead. (See Figure 4-20)
5.1.1 Adjustment Items (p.134)
Disassembly and Assembly
Figure 4-21. Forming the FFC beside the Printhead
FFC
Removal of Exterior Parts
Form the CR Encoder FFC as
shown, and connect it to the
Valve Assy
Mountain-
Ink Tube Assy
shaped paper
*Do not forget to
remove the paper
after installing
the Valve Assy.
Figure 4-22. Installing the Valve Assy
Revision A
connector
Tube Guide
93