Paper Guide Front Assy (Platen) - Epson Stylus Photo RX700 Service Manual

EPSON Stylus Photo RX900

4.4.13 Paper Guide Front Assy (Platen)

1. Remove the Linear Scale. (p.91)
2. Remove the Printer Mechanism. (p.107)
3. Remove the Carriage Assy. (p.116)
4. Disengage the hooks (x2), and remove the Left EJ Frame Release Guide.
5. Lift the front side while disengaging the hook in the middle of the Paper Guide Front
Assy and disengage the right and left shaft holder portions, and remove it from the PF
Roller Assy.
C A U T I O N When installing the Paper Guide Front Assy, bend the waste ink
guides (x2) of the Paper Guide Front Assy inward so that the waste
ink will flow into the Waste Ink Pads under the Printer
Mechanism.
Lubrication is necessary. Refer to the following section and
lubricate the specified points:
•Lubrication of Paper Guide Front Assy (p.152)
When installing the Paper Guide Front Assy, put the right side
shaft holder portion under the shaft of the PF Roller Assy, and
place the Paper Guide Front Assy so that the projection of the
right frame enters the corresponding hole.
Disassembly and Assembly
PF Roller
軸受部を軸下に入れる
Put the shaft holder
portion under the shaft
The projection of the frame must
enter the corresponding hole
Disassembly and Assembly of Major Parts of Printer
Left EJ Frame Release Guide
Bend the waste ink
guides (x2) inward
PF Roller
Figure 4-58. Removing the Paper Guide Front Assy
Revision A
~ Rear ~
Hooks (x2)
Paper Guide Front Assy
119