Printer Mechanism - Epson Stylus Photo RX700 Service Manual

EPSON Stylus Photo RX900

4.4.4 Printer Mechanism

1. Remove the Middle Housing. (p.88)
2. Remove the ASF Rear Assy. (p.103)
3. Remove the I/C Holder Assy. (p.105)
4. At the rear of the printer, remove the screws (x2) (one of them secures the Power
Supply Assy Shield Plate together).
5. Remove the screws (x2) securing the Harness Clamp.
6. Remove the screws (x5) securing the Printer Mechanism.
7. Release the tube clamps, and disconnect the Waste Ink Tubes (x2) from the Tube
Holder.
8. Remove the Printer Mechanism with care that it is not caught by lead wires.
C A U T I O N When you remove the Waste Ink Tubes, ink may blow out. Take
great care not to stain any surrounding objects with ink.
When installing the Waste Ink Tubes, make sure that they are all
the way seated in the locations shown below.
(Continued to next page)
Disassembly and Assembly
Tube Holder
Tube clamps (x2)
Waste Ink Tube (Red)
Waste Ink Tube (Blue)
Disassembly and Assembly of Major Parts of Printer
Printer Mechanism
⋅
Torque: 0.6 ± 0.1N m
C.B.P-Tite 3x8 F/ZN-3C (x2)
Harness Clamp
Lower Case Assy
Figure 4-39. Removing the Printer Mechanism
Revision A
C.B.P-Tite 3x8 F/ZN-3C (x5)
⋅
Torque: 0.6 ± 0.1N m
⋅
Torque: 0.8 ± 0.1N m
C.B.S-Tite 3x6 F/ZN-3C
Torque: 0.8 ± 0.1N
C.B.S-Tite(P4) 3x6 F/ZN-3C
107
⋅
m