Network Interface (Nx510 Series Only) - Epson Stylus NX510 Service Manual

Epson Stylus NX510/515/SX510W/515W/TX550W/NX415/SX410/415/TX410/419/NX215/SX210/215/TX210/213/219/ME OFFICE 510
Table 1-22. Device ID
When IEEE 1284.4 is Enabled
@EJL<SP>ID<CR><LF>
MFG:EPSON;
CMD:ESCPL2,BDC,D4,D4PX,ESCPR1;
MDL:Model Name;
CLS:PRINTER;
DES:EPSON<SP>Model Name;
CID:EpsonRGB;
The " " is replaced as shown in the following table.
Model Name
Table 1-23. Model Names Indicated in the Device ID
Destination North America
Epson Stylus Epson Stylus
NX510 series
NX510
SX410 series TBD
Epson Stylus Epson Stylus
SX210 series
NX210
PRODUCT DESCRIPTION
When IEEE 1284.4 is Disabled
@EJL<SP>ID<CR><LF>
MFG:EPSON;
CMD:ESCPL2,BDC;ESCPR1;
MDL:Model Name;
CLS:PRINTER;
DES:EPSON<SP>Model Name;
CID:EpsonRGB;
Latin/Asia/
Euro China
Pacific
Epson Stylus
SX510W TX510W
TBD TBD
Epson Stylus Epson ME
SX210 TX210 OFFICE 510

1.5.2 Network Interface (NX510 series only)

NX510 series can be connected to the network via Wired or Wireless LAN connection.
(They can not be used simultaneously.) The following describes each Interface.
Wired LAN
The following interface is equipped for the Wired LAN connection. The
communication mode can be selected from auto setting or fixed setting.
Item
Connector
Communication Speed
Note* : 10Base-T/100Base-TX Ethernet is supported. MDI/MDI-X is selected automatically.
---
Table 1-25. Combination of the Wired LAN communication mode settings
Setting of this printer
---
Auto Setting
100BASE-TX Full Duplex
100BASE-TX Half Duplex
10BASE-T Full Duplex
10BASE-T Half Duplex
Interface
Table 1-24. Wired LAN
Content
RJ-45 receptacle * : 1 port
For either 10Base-T or 100Base-TX, the Full Duplex or Half
Duplex can be selected.
Setting of the connected device
Auto Setting (AUTO)
100BASE-TX Half Duplex
10BASE-T Half Duplex
100BASE-TX Full Duplex
Auto Setting (AUTO)
100BASE-TX Half Duplex
10BASE-T Full Duplex
Auto Setting (AUTO)
10BASE-T Half Duplex
Revision A
24
Confidential